Bretford lap18eulba User Manual download pdf (Page 5)

Step 5

Reinstall the E-Units (set aside from being removed from the front) as follows:

1. Rotate the E-Unit 180 degrees (from original position).

2. Cross over to opposite corner of cart.

3. Tilt in and set bottom in back corner.

4. Grip the top and tilt to the upright position.

When repositioned correctly, the E-Unit outlets face the interior and power switch should be visible from rear

panel cutout.

Reinstall the E-Unit bracket assemblies (make sure that the top flange of the E-unit is aligned with the slot in the

bracket assembly) and tighten screws securely.

Plug in the E-Units power cords into the bottom outlets of the timer assembly.

(Note that the 'A', 'B' designation of the cords are now opposite the timer 'A, 'B' designation set at the factory.

This will not affect the operation of your cart.)

Press each E-Unit power cord into the single wire clip located at the rear/bottom of the cart only.

Fold the power cords into a 's' pattern, flat on the bottom surface.

clip

1 2 3 4 5 6 7 8 9 10 ... 32 33

No comments

Bretford lap18eulba User Manual Page 5